A.S-1 interface is an on--the-spot bus-mastering
system, which can connect actuator and sensor
(detector) to higtner control equipment (pmcipal
controller).
• Creating a ~I network requires electricaJ
source, one or several main control modules,
bus cable (actuating cable) and C-Top
prepared for AS-I connection (special built-in
card, connection cable, isolated displacement
connector)
• Voflage of AS-t on-the~pot concentration line is
supplied by elecbical source.
• Sensor and electromagnetic valve are controlled
by main oontrof module.
• Each principal controller OOIWeys information to
PlC and can control up to 31 C-Top units
• Interconnection is realized through actuating
cable. Actuating cable is used to convey
information and is also used for supplyilg
electrical source for electromagnetic vatve and
detector.
• C-Top of AS-I version must be installed with
inductive detector and 24V DC.
• Connect C-Top aotuating cable to bus cable
through isolated displacement connector,
therefore, it is Not required to connect each
C-Top to control system through cable.
concentration line can be used to connect
sensor to electromagnetic valve( actuator) in a
simple, fast and ecoNomical way. Reduction in
cabling wor1<1oad facilijates factory's assembly
and startup greatly, even shortening startup time
and avoiding some installation mistakes that
might occur.
• Parts are same as standard C-Top. Only
changed parts are built-in card, connection
cable and connector itself of AS-I insulation
disp~cement connector.
• Single action: one electromagnetic valve
• Double action: two electromagnetic valves
• An~mtxing dual seat valve: three
electromagnetic valVes
• Open or closed valve position: one inductive
detector,two inductive detectors
• lifting (Double seat, anti-mixing valve): three
inductive detectors
• Valve position: open, closed, lower position lifting
valve used for washing
• Maximum C-Top unit: 31 group (or auxiliary)
• Connection cable.: 2m
• Bus cable: maximum 1m
• Bus cable (excluded): 21ines are used for data
and 30V DC voltage.
• ~~card specification: 2.1
• ~~ card maximum capacity: 4 input and
4 output (4 electromagnetic valves and 4
detectors)